Hello, "Robert Smith" skribis: >> https://web.fdn.fr/~lcourtes/software/guix/1.1.0rc2 > > I ran into the same issue that Jesse encountered in December, the > installer hangs when it tries to connect to wifi, and I can't escape by > pressing Alt-F2/F3/F12. When you’re on tty1 (the installer), you have to hit Ctrl-Alt-F12 etc. (note “Ctrl”). Is it what you tried? > In the end I just have to hold down the power button. I've tested this > with different wifi networks and it's always the same. I tried using > the console to connect to wifi, and everything worked smoothly. The > only difference from the manual was that I had to use `rfkill unblock > wifi` before I could bring the interface up. I didn't have this issue > when I first installed guix, so I downloaded the 1.0.1 installer and > as I thought the issue wasn't there, and the wifi connection went > smoothly. OK. It could have something to do with the issue about Connman not starting that Florian reported. What does /var/log/messages show? (In particular, messages from shepherd, connmand, and dbus.) > I'm not sure how I can get any diagnostic information from my system, if > you have ideas I'd be happy to try them out. I tested this on my Librem > 15 v4; I remember from Guix Days that a few other people have Librem > laptops, I'm curious if they can use the installer to connect to a wifi > network. Anyone else with a Librem laptop can give it a try? You don’t need to run the full installation, it’s enough to go past the network setup phase, which is early on. Thanks for your report, Ludo’.